Match PP 41DSP - Technical Specifications; Output Power and Frequency; DSP and Signal Performance; Input and Voltage Parameters

Output power RMS / max:
• Front / Rear channels @ 4 Ohms: .............................4 x 35 / 70 Watts
• Front / Rear channels @ 2 Ohms: .............................4 x 50 / 100 Watts
Frequency range .............................................................20 Hz - 22.000 Hz
Number of input channels................................................4 x highlevel
DSP resolution .................................................................56 Bit
DSP processing power ....................................................50 MIPS
Total harmonic distortion (THD) .......................................< 0,03%
Signal-to-noise ratio.........................................................> 100 dB
Damping factor ................................................................> 100
Input impedance ..............................................................30 Ohms
Undervoltage detection....................................................9,6 Volts (max. 5 sec. down to 6 Volts)
Overvoltage detection......................................................17 Volts
Dimensions (H x W x D) ..................................................44 x 185 x 124 mm / 1,73 x 7,28 x 4,88“
Additional features ...........................................................fully stabilized internal power supply with start-
stop capability, 56 bit digital signal processing,
internal memory for a maximum of 16 different
sound setups, 2-digit LED display for indicating
the chosen setup
The limited warranty comply with legal regulations.
Failures or damages caused by overload or impro-
per use are not covered by the warranty.
Please return the defective product only with a
valid proof of purchase and a detailed malfunction
description.
Technical specications are subject to change!
Errors are reserved!
For damages on the vehicle and the device, caused
by handling errors of the device, we can’t assume
liability.
All MATCH ampliers are tagged with a E-Certi-
cation number and also a CE-Certication mark.
Thereby these devices are ceritied for a use
inside vehicles inside the European Union (EU).
Technical Data
Warranty Disclaimer