Need help?Do you have a question about the Match PP 82DSP and is the answer not in the manual?
General| Channels | 8 |
|---|---|
| DSP Resolution | 64 Bit |
| DSP Power | 295 MHz |
| Sampling Rate | 96 kHz |
| Damping factor | > 100 |
| Highlevel input impedance | 13 Ohms |
| Amplifier Class | Class D |
| Signal-to-noise ratio analog input | 103 dB |
| Signal-to-Noise Ratio | 105 dB |
| Input Sensitivity | 0.2V - 6V |
| Operating voltage | 10.5 - 16 V |
| Additional features | Start-Stop capability |
| Dimensions (H x W x D) | 50 x 290 x 190 mm |
| Frequency Response | 20Hz - 20kHz |
Read this manual carefully and follow all installation instructions to prevent damage and injury.
Guidelines for connecting the PP 82DSP amplifier to the vehicle's electrical system.
Covers Output Channels, Line Output, Optical Input, and AUX Input connectors.
Step-by-step instructions for connecting the amplifier to the car radio.
Guidance on adjusting amplifier gain using MODE switches based on radio volume.
Software for detailed configuration of the PP 82DSP amplifier's DSP functions.
To Next Page
