Match PP 82DSP - Connectors and Control Units; Input;Output Connectors; System and Power Connectors; Control and Data Interfaces

14
Connectors and control units
6
1
Output Channels E - H
Connector for the loudspeakers of the chan-
nels E – H. Alternatively you can directly con-
nect a passive MATCH PP subwoofer.
2
Line Output
Line outputs for connecting external ampli-
ers. Make sure that the „Remote Output” is
used to turn on these devices.
3
Optical Input
Optical input in SPDIF format for digital ste-
reo signals
4
AUX Input
3,5 mm jack for an external audio source like
a MP3-player, navigation device, etc.. This
input can either be activated automatically or
via an optional cable remote control.
5
System Connector
Connector for the MATCH cable harness.
Make sure that you only use the original ca-
ble that comes with the amplier to connect
the PP 82DSP with your car radio.
6
Fuse
This LED will light up if the fuse inside the
unit is blown.
7
+12V
Connector for the +12 V power cable to the
positive terminal of the battery.
8
Rem Out
The remote output has to be used to turn on/
off external ampliers that are connected to
the RCA line outputs.
9
GND
Connector for the ground cable (negative
terminal of the battery or metal body of the
vehicle).
10
MODE Switch / DIP Switch
Allows modifying amplier gain and subwoo-
fer gain as well as functionality of the optional
remote control URC 2A.
11
Control Input
Multifunction interface for e.g. the optional
remote control URC 2A or other accessory.
12
USB Input
Connects the PP 82DSP to your PC.
13
Status LED
This LED indicates the operating mode of the
amplier and the setup that has been chosen
14
Control pushbutton
Use this button to either switch between the
setups or initiate a reset of the device.
15
MicroSD card reader
MicroSD card reader for uploading complete
DSP setup les.
7
8
9
10 11 12 13 14 15
1 5432