Matco Tools MM200 LCD - Page 13

MAINTENANCE AND TROUBLESHOOTING
- Ⅳ -
Welding parameters
available by rotating L
Knob
Welding parameters
available by rotating R
Knob
Two/four Stroke
2T/4T
Burn Back
0-10
Slow Feed
0-10
Pre-flow
0-2 S
Post Flow
0-10 S
Inductance
0-10
Fig. 2
4. Selection of system setting parameters:
1) In the main interface, rotate the R knob to parameter setting interface;
2) Rotate L knob to select system settings:
5. Setting of welding current and voltage
1) Press the ENTER key to enter the welding interface shown below: