Matelec Hydrowhiz FPC-63X21 User Manual

3
MATelec Australia reserves the right to alter technical data without notice
Step 5 - Setup
PUMP 1
RUNNING MENU
Standby Run
PUMP 2
Fault
PUMP 3
Disabled
PUMP 4
Duty Run
SYSTEM MODE:
AUTO
OFF
MANUAL
546kPa
View Faults
32.5Hz
5.1 - Main Screen
The Main screen is the default screen on the HydroWHIZ HMI.
Tap on the Menu button to access the Menu screen.
5.2 - Menu Screen
The Menu screen provides access to other screens within the
HydroWHIZ HMI. Tap on the Date & Time icon to configure the
controller’s current date and time.
Main Screen Alarms Logged Data Trend Plot
Setup All Parameters Date & Time Diagnostics
RUNNING 10/06/2020 17:50:58
5.5 - Login
Login is required to access the Setup screen. Enter the default
PIN (2020) then press OK to login in and continue to the Setup
screen.
RUNNING
Enter PIN:
LOGIN REQUIRED !
10/06/2020 17:50:58
OK
321
654
987
0
CANCEL
2020
5.6 - Warning
If the system mode is in auto, tapping on a setting will bring
up a Warning screen. Press OK to turn the system off for
configuration.
RUNNING MENU
System type
Control output type
Number of pumps
Pump limit
Duty change period
Setup: 1 System Setup
Level
DOL
4
6
60 Mins
Warning
Changing this parameter could result in
unexpected behaviour.
Switch system to o󰀨?
Cancel
OK
5.3 - Set Date & Time
Tap on the date and time to configure them, then press save
to apply to the controller. This will automatically return to menu.
RUNNING MENU
Set Time and Date:
Current Time:
10/06/2020 17:52:08
Current Date:
17 : 52 : 08
10 : 06 : 2020
Save
5.4 - Menu Screen
Tap on the Setup icon on the Menu screen to access begin
the controller Setup process. This will bring up the Login screen.
Main Screen Alarms Logged Data Trend Plot
Setup All Parameters Date & Time Diagnostics
RUNNING 10/06/2020 17:50:58

Matelec Hydrowhiz FPC-63X21 Specifications

General

Brand	Matelec
Model	Hydrowhiz FPC-63X21
Category	Controller
Language	English