14| Revision Date: 8/30/2017 | Revised by: EM
6. Next, press Enter 3 0 0 1 Enter to go to Service Mode, and then press the Hardware tab. (The LCM listing on the page now shows “Update”, which
means new LCM software is available in the CF card.)
7. Press Update. The LCM software updates. Note: Press the update key one time only and wait a few seconds for the upgrade process to begin.
The scre
en will show the install status as a green bar.
8. When the upgrade is complete, the LCM version will automatically change to the new version.
9. Test the unit.
To Next Page
Loading...
