Matrix 92552 - Proper Use

7
• Turn o the power tool if the blade gets
stuck in the workpiece or the workpiece gets
wedged.
• Warning: Do not use blades made of high
speed steel.
• Keep the oor area free of loose particles
such as wood chips and cutos.
• Make sure that the blade speed indicated on
its label is at least as high as that of the saw
speed.
• Use gloves when handling saw blades and
rough materials.
• Be sure to use only shims and spindle rings
that are suitable for the purpose specied by
the manufacturer.
• Warning: Do not remove cuttings or other
parts of the work piece from the cutting area
while the machine is running and the saw has
not yet come to a complete stop.
• Always clamp the work piece to the saw
table.
• Make sure that the machine is sitting securely
before beginning to saw.
WARNING! Noise can be harmful to your
health. If a sound level of 85dB (A) is exceeded,
ear protection must be worn.
Before each use, all guards and other parts
should be carefully inspected to see whether
they still fulll their functions.
Check for alignment, smooth operation,
breakage or other damage that could impair
function. A damaged part should either be
immediately and professionally repaired or
replaced.
Hazard from blocking work pieces or parts!
If blockage occurs, please proceed as follows:
1. Switch the device o
2. Unplug it
3. Wear gloves
4. Clear blockage with appropriate tools.
Layout
Parts list refers to gures on pages 2 and 3.
1 Grip
2 Start switch
3 Base
4 Joint for casing / base
5 Rotary table
6 Motor
7 Saw blade
8 Table insert
9 Saw blade guard, xed
10 Saw blade guard, moveable
11 Chip bag
12 Clamping jaw
13 Locking button
Proper Use
• The machine must only be used in technically
perfect condition in accordance with its
designated use and the instructions set out in
the operating manual, and
only by safety-conscious persons who are fully
aware of the risks involved in operating the
machine. Any functional disorders, especially
those aecting the safety of
the machine, should therefore be rectied
immediately.
• Any other use is unauthorized. The
manufacturer is not responsible for any
damages resulting from unauthorized
use; risk is the sole responsibility of the
operator.
• The safety, work and maintenance
instructions of the manufacturer as well as the
technical data given in the calibrations and
dimensions must be adhered to.
• Relevant accident prevention regulations and
other, generally recognized safety- technical
rules must also be adhered to.