9
CLIMBMILL ASSEMBLY
There are several areas during the assembly process that special attention must be
paid. It is very important to follow the assembly instructions correctly and to make sure
all parts are firmly tightened. If the assembly instructions are not followed correctly,
the unit could have parts that are not tightened and will seem loose and may cause
irritating noises. To prevent damage to the unit, the assembly instructions must be
reviewed and corrective actions should be taken.
Before proceeding, find the unit’s frame serial number located as shown in the
illustration and enter it in the space provided below. The console serial number
is located on a barcode sticker on the console, near the connection between the
console and the mast.
ENTER YOUR SERIAL NUMBERS AND MODEL NAME IN THE BOXES BELOW:
» Use the information above for initial setup and when calling for service.
WARNING
FRAME SERIAL NUMBER:
CONSOLE SERIAL NUMBER:
MODEL NAME:
MATRIX
CONSOLE SERIAL NUMBER LOCATION
FRAME SERIAL NUMBER LOCATION
To Next Page
Loading...
Need help?
General
