Matrix DWS 600-1 User Manual

20
When choosing grinding disc, please observe the
manufacturer's specications. The sand paper
beyond the grinding block leads to risk of cutting
and injury and cause stuck as well.
11. .The machine can be connect to one
extension tubes at most.
12. We recommend that you always wear
industrial safety gloves and safety goggles when
working with the drywall sander.
13. Wearing close-tting clothes is mandatory.
14. Always allow for reaction torque
15. Wear protection mask P2 to protect you from
hazardous dusts and choose suitable vacuum
cleaner.
INTENDED USE
The intended use of this power tool is the
sanding of large areas of drywalls as a
preparation before painting or wallpapering
using suitable abrasive sheets.
This power tool is neither suited for the
preparation of small areas, corners and edges,
nor for the removal of wallpaper and the
grinding of ceilings and wet grinding.
Do not use the power tool for cutting or
roughing or polishing. Do not use it together
with wire brushes. Do not treat
asbestoscontaining
materials with this power tool.
This power tool is solely intended for private
use. Do not use the power tool for any other
purpose than for the intended one. Any other
use beyond the intended use is improper.
For any resulting damage or injury, the user/
operator is held liable, not the manufacturer.
TECHNICAL SPECIFICATIONS
Reference DWS 600-1
Nominal voltage 230-240 V ~ 50 Hz
Input power 600 W
No-load speed 600 – 1500/ min
Platen diameter 210 mm
Output shaft screw thread M6
Acoustic pressure level L
pA
85 dB(A), K = 3 dB(A)
Acoustic power level L
WA
96 dB(A), K = 3 dB(A)
Level of vibration a
h
=3,18 m/s², K = 1,5 m/s²
NOISE/VIBRATION INFORMATION
Measured sound values determined according to
EN 60745.
Wear hearing protection!
Vibration total values (triax vector sum)
determined according to EN 60745:
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in EN
60745 and may be used to compare one tool
with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level represents
the main applications of the tool. However if
the tool is used for dierent applications, with
dierent accessories or poorly maintained,
the vibration emission may dier. This may
signicantly increase the exposure level over the
total working period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched o or when it is
running but not actually doing the job. This may
signicantly reduce the exposure level over the
total working period.
Identify additional safety measures to protect the
operator from the eects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organization of work patterns.

Matrix DWS 600-1 Specifications

General

Brand	Matrix
Model	DWS 600-1
Category	Sander
Language	English