CHAPTER 4: Elliptical parts and assembly Guides
4.3 ASSEMBLY STEPS
CONSOLE MAST
Thread the Console Mast through the Console Mast Boot.
Feed the cable through the Console Mast. Tape the cable to the top of the
Console Mast to secure it temporarily.
Attach the Console Mast to the Base Frame using two screws (Z03), four
washers (Z04) and two nylon nuts (Z07). Ask your assistant to hold the
Console Mast while tighten screws.
Fix the water-holder bracket to the console mast using 2 bolts and then
use #5 L-type wrench to tighten the screws.
CONSOLE
Connect the cable inside the Console, and unscrew the screws attached
the back of the Console.
Attach the Console to the top of the Console Mast using the same screws
attached the back of the Console.
1)
2)
3)
1)
2)
Lift up the Main Body at the front end. Ask your assistant to insert the
wooden or hard box underneath the Main Body while you lift up the
Main Body.
Fasten the Front Foot to the Main Body by using two screws (Z10).
1)
2)
To Next Page
Loading...
