Matrix EPS-HT 710 S - Page 40

40
• adjusting the working position of the cutting
device,
• leaving the power tool unattended.
b) Ensure that the machine is correctly located
in a designated working position before starting
the engine.
c) While operating the machine, always ensure
that the operating position is safe and secure,
especially when using steps or a ladder.
d) Do not operate the power tool with a damaged
or excessively worn cutting device.
e) Always ensure that all handles and guards are
tted when using the power tool. Never attempt
to use an incomplete machine or one tted with
an unauthorized modication.
f) Always use two hands to operate a machine
tted with two handles.
g) Always be aware of your surroundings and stay
alert for possible hazards of which you may not
be aware due to the noise of the machine.
Maintenance and storage
a) When the machine is stopped for servicing,
inspection or storage, shut o the power source,
and make sure all moving parts have come to
a stop.
b) Store the machine where the fuel vapour will
not reach an open ame or spark. Always allow
the machine to cool down before storing.
c) When transporting or storing the machine,
always t the cutting device transport guard.
Additional safety instruction
- THIS MACHINE CAN CAUSE SERIOUS INJURIES.
Read the instructions carefully for the correct
handing, preparation, and maintenance, starting
and stopping of the machine. Be familiar with all
controls and the proper use of the machine;
- Never allow children to use the machine;
- Beware of overhead power lines;
- Avoid operating while people, especially
children are nearby;
- Dress properly! Do not wear loose clothing or
jewellery which can be caught in moving parts.
Use of sturdy gloves, non-skid footwear, and
safety glasses is recommended;
- Stop the engine or disconnect from mains
before:
• Cleaning or when clearing a blockage;
• Checking, maintenance or working on the
machine;
• When adjusting the working position of the
cutting device.
- Where the machine is provided with
adjustments to the angle of the cutting device
and / or the length of the handle shaft, never
hold the cutter blades when making adjustments
to the working position of the cutting device.
- Always ensure that the cutting device is
correctly located in a designated working
position before starting the engine or plugging
the machine into the mains
- While operating the machine be always sure of
a safe and secure operating position especially
when using steps or a ladder;
- Do not operate the machine with a damaged or
excessively worn cutting device
- Beware of noise level wear the ear protection;
- Always ensure all handles and guards are tted
when using the machine. Never attempt to use
an incomplete machine or one tted with an
unauthorized modication;
- Where a machine is provided with more than
one handle always use two hands to operate it;
- When transporting or storing the machine
always t the cutting device guard;
- Instructions for correct use and an indication
that the machine should not be used for any
other purpose;
- Know how to stop the machine quickly in an
emergency;
- Always be aware of your surroundings and stay
alert for possible hazards that you may not hear
due to the noise of the machine.
- Keep all parts of the body away from the cutter
blade. Do not remove cut material or hold
material to be cut when blades are moving. Make
sure the unit is unplugged and the switch is o
when clearing jammed material. A moment of
inattention while operating the machine may
result in serious personal injury.
- Carry the machine by the handle with the cutter
blade stopped. When transporting or storing
the machine always t the cutting device cover.