49
anywhere and disconnect it from the power
supply.
- Always cover the cutter blades with supplied
guard and carry the product at the handle in
horizontal position during transport.
- Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles. Secure the product to
prevent it from slipping or falling over.
Repairs
Only use accessories and spare parts
recommended by the manufacturer. If despite
our quality controls and your maintenance the
device fails, have repairs only carried out by an
authorized electrician. If the connection line of
this device is damaged, it has to be replaced by
the manufacturer or their representation or an
electrician in order to avoid safety risks.
This marking indicates that this product
should not be disposed with other
household wastes throughout the EU.
Recycle it responsibly to promote the sustainable
reuse of material resources. To return your used
device, please use the return and collection
systems or contact the retailer where the product
was purchased. They can take this product for
environmental safe recycling.
3. If cutter teeth have hit hard objects such as
nails and stones, or have been abraded by mud
or sand on the wood, have service dealer sharpen
chain.
How to sharpen the cutters(A32)
Be careful to le all cutters to the specied angles
and to the same length, as fast cutting can be
obtained only when all cutters are uniform.
- Wear gloves for protection.
- Tighten the chain tension enough that the chain
does not wobble.
- Use a 4 mm diameter round le and holder. Do
all of your ling at the mid-point of the bar. Keep
the le level with the top plate of the tooth. Do
not let the le dip or rock. Using light but rm
pressure, stroke towards the front corner of the
tooth. Lift le away from the steel on each return
stroke.
- Put a few rm strokes on every tooth. File all left
hand cutters in one direction. Then move to the
other side and le the right hand cutters in the
opposite direction. Occasionally remove lings
from the le with a wire brush.
WARNING:
Improper chain sharpening increases the
potential of kickback. Failure to replace or
repair damaged chain can cause serious
injury.
Storage
- Clean all foreign material from the product.
- Store the unit indoors in a dry and well-
ventilated area that is inaccessible to children.
- Keep away from corrosive agents such as
garden chemicals and de-icing salts.
- Always place the blade guard on the blade
when transporting or storing the machine. The
blade guard is a snug t and must be attached
very carefully due to the sharp blade. Always
wear protective gloves when handling.
Transportation
- Switch the product o before transporting it
To Next Page
Loading...