MG-MR690-04 FRAME ASSEMBLY
5. Upright support and Weight Storage Top: Using (16) 3/8-16 x 1” bolts and
(16) 3/8” washers, attach the upright support to the top of the uprights and top
of the weight storage. Do not tighten bolts.
6. Upright/Chin bar support: Using (8) 3/8-16 x 1” bolts and (8) 3/8” washers,
attach the upright/chin bar supports between the rear (2) uprights. Do not
tighten bolts.
7. Chin bar: Using (4) 3/8-16 x 1” bolts, (4) 3/8” washers, (4) 1/2-13 x 4 1/2” bolts,
(8) 7/16” washers and (4) 1/2-13 nuts, attach the chin bar between the top
upright supports. Do not tighten bolts.
8. Tighten bolts: Starting with the bottom of the uprights and working up to the
top of the machine, tighten all bolts to 30 ft-lbs.
Assembly Complete!
STEP 5
STEP 6
STEP 7
To Previous Page
Loading...
