Matrix Mini-i - Technical Specifications

24-Bit /192kHz High Performance Stereo Audio Processor MATRIX
SYMPTOMS CAUSES REMEDIES
Off power z It might be not plugged into a
proper AC or turned off
z Make sure the power
cable is connected to a
proper AC
NO SAMPE shown
all the time
z Digital input cable disconnected or
no input signal
z Digital signal outputs abnormally
z Make sure the digital
input cable is linked up
correctly
z Check the digital signal
output
No analog output z Analog port disconnected
z Volume has been turned to
minimum
z Connect the audio cable
correctly
z Adjust the volume
No Headphone
output
z It might be working under the DAC
Mode
z Switch to the Pre-mode
GENERAL MALFUNCTION:
Common breakdowns might be caused by an interrupted AC power. Or the device is
troubled by static electricity. Under these circumstances, turn it off and unplug the
main power at least for a minute, then reconnect and restart it.
● TECHNICAL SPECIFICATIONS
DIGITAL INTERFACE:
INPUT:
OPTICAL: Shielded/enclosed optical input Sampling Rate: 44.1kHz ~192kHz
BNC : Standard BNC 75 ohm Sampling Rate: 44.1kHz ~192kHz
USB r: Standard USB-B connector Sampling Rate: 44.1kHz ~48kHz
AES/EBU: Standard XLR interface Sampling Rate: 44.1kHz ~192kHz
OUTPUT:
Coaxial Output: standard RCA jack Supports AC-3, DTS data output
Sampling Rate: 44.1kHz ~192kHz Output Level: 1Vp-p (75 ohm)
ANALOG INTERFACE:
RCA Output Level: 0V~ 2.0V adjustable
Balanced Output Level: 0V~ 4.0V adjustable (XLR : 1=GND, 2=HOT, 3=COLD)
Frequency response: 20Hz~20KHz
SNR: 105 dB
Dynamic Range: 108 dB
Distortion : ＜0.0002%（1KHz）
POWER REQUIREMENT:
Power： AC 220V 50/60Hz (AC 110V in U.S.)
Power consumption： ＜15W
- 7 -