CHAPTER 4: Programming & engineering mode
CODE: INFORMATION DEFAULT MIN MAX
P0:
Maximum progam time - 95 min 10 95
P1:
Default workout time - 20 min 10 MAX
P2: Default resistance level - 1 1 25
P3: Default user weight - 150 lbs. /75 kg 80 400
P4: Speed units
- mi
P5: Machine Type - Swing Ramp
P6: Console beep on / off - on
P7:
Accumulated distance -
P8: Accumulated time -
P9:
Display language - English
P10: Software version -
P11: Incline calibration -
P12: Incline reset - on
P13: Default incline level - 10 0 100
P14: Error Code -
NOTE: DEFAULT TIME will update to the same as MAX TIME if MAX TIME is less
than DEFAULT TIME.
4.3 ENGINEERING MODE
To enter Engineering mode, hold the UP and DOWN elevation keys for three
seconds until “MANAGER” appears on the middle LED display. Press the
DOWN arrow key and “ERROR CONTROL” will appear on middle LED display.
Error Control, Do not use this mode unless you are a qualified technician. Error
control will determine if a machine is disabled once Class A or Class B errors
are registered by the software.
Incline Record, log of incline motor and total program activity. This record holds
the total number of hours for each program (MANUAL, ROLLING, INTERVAL,
etc.) as well as incline motor activity in hours. This can be a useful tool for the
club manager of trainer when reviewing machine usage.
• To enter INCLINE RECORD, press
SELECT when INCLINE RECORD is displayed.
• Totals are stored permanently unless reset by a technician. To reset error codes, hold
MANUAL and RANDOM keys for three seconds. Refer to accumulated hours when
calling Matrix technical service for assistance. (Insert chart)
Incline Tuner, Do not use this mode unless you are qualified technician. Incline
Tuner allows calibration and resetting of the incline motor range of motion.
Service 1,2,3,4 are described in the Matrix Technical Service Guide.
To Next Page
Loading...
