4.3
INPUT CONTROL
...............................................................................................................................................
21
4.3.1 Short circuit operation (SHORT)
..........................................................................................................
21
4.3.2 Input switch operation
.........................................................................................................................
21
4.4 E
LECTRONIC LOAD OPERATING RANGE
...............................................................................................................
21
4.5
PROTECTION FUNCTION
....................................................................................................................................
22
4.5.1 Over-voltage protection (OVP)
...........................................................................................................
22
4.5.2 Overcurrent protection (OCP)
.............................................................................................................
22
4.5.3 Over Power Protection (OPP)
..............................................................................................................
22
4.5.4 Reverse input polarity
..........................................................................................................................
22
4.5.5 Over Temperature Protection (OTP)
...................................................................................................
23
4.6
REMOTE TEST FUNCTION
...................................................................................................................................
23
4.7
BATTERY DISCHARGE TEST OPERATION
...............................................................................................................
23
4.8 COMMUNICATION PROTOCOL
.....................................................................................................................
24
4.8.1 Overview
................................................................................................................................................
24
4.8.2 Select the communication baud rate
..................................................................................................
25
4.8.3 Data
........................................................................................................................................................
25
4.8.4 Function Code
.......................................................................................................................................
25
4.8.5 error checking
.......................................................................................................................................
25
4.8.6 Complete command frame parsing
....................................................................................................
25
4.8.7 Coil and register address assignment
.................................................................................................
28
4.8.8 Command Register CMD Definition
...................................................................................................
30
4.8.9 Common operation function description
...........................................................................................
31
To Next Page
Loading...
