5
INSTRUCTIONS
Start with the leveling feet all the way up (turn clockwise). Once the Climbmill is placed, the frame should be resting
on the floor. If the Climbmill is not level, adjust the levelers as needed using a 6 mm Allen socket.
1. For Performance & 7, 5 Series frames, remove the dust tray and control zone (Fig. 1).
2. For Endurance & 3 Series frames, remove the end caps to access the levelers (Fig. 2).
TOOLS NEEDED
• 6 mm Allen socket and ratcheting wrench
CARDIO EQUIPMENT
LEVELING EQUIPMENT: CLIMBMILLS
PER
FORMANCE, ENDURANCE & 7, 5, 3 SERIES CLIMBMILLS
FIG. 1 FIG. 2
To Next Page
Loading...
