19
- Before you switch off the generator, allow it to
run briefly with no consumers so that it can "cool
down”.
- Turn the ECS switch to "OFF"
- Disconnect any electric devices
- Move the Engine switch (11) to position "STOP”.
- Turn the fuel cock knob to"OFF"
- Turn the fuel tank cap air vent knob to
"OFF"after the engine has completely cooled
down
7.5 Overload cut-out for socket-outlets
Important!
The generator is fitted with an overload cutout.
This shuts down the sockets (4). You can restart
the sockets by restart the generator.
Important!
If this happens, reduce the electric power you
are taking from the generator or remove any
defective connected appliances.
Important!
Defective overload cut-outs must be replaced
only by overload cut-outs of identical design and
with the same performance data. If repairs are
necessary, please contact your customer service
center.
8. Cleaning, maintenance and storage
Switch off the generator and pull the spark
plug boot from the spark plug before doing
any cleaning and maintenance work on the
equipment.
8.1 Cleaning
- Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
3. The ECS switch must be turned to"OFF" when
using electric devices that require a large starting
current, such as a compressor of a submergible
pump.
- Connect the equipment you want to use to the
socket outlets (3/4)
Important!
- Never connect the generator to the domestic
power network as this may result in damage
to the generator itself or to other electrical
appliances in your home.
- Switch off the machine immediately and contact
your service station:
- If the generator is making unusual vibrations or
noise.
If the engine is overloaded within rated load
range or misfires.
Note: Some electrical appliances (power jigsaws,
drills, etc.) may have a higher level of power
consumption when used in difficult conditions or
starting.
- Use the supplied DC connecting cable to make
connection to 12VDC powered appliance. (B18)
Important!
The 12 V DC output of the generator is not
treated by a precise electric circuit.
Never use it to power any precise DC instrument.
Important!
When using the generator to powering a heating
device. Please do keep the powered heating
device far from the generator.
7.4 Switching o the engine
- Turn off any electric devices.
UK
To Next Page
Loading...
Need help?
General
