Matrix S-DRIVE PERFORMANCE TRAINER - Maintenance; General Maintenance Guidelines; Maintenance Schedule; Product Specifications

11
MAINTENANCE SCHEDULE
ACTION FREQUENCY
Clean entire machine using water and a mild soap
or other Matrix approved solution (cleaning agents
should be alcohol and ammonia free).
DAILY
Check harness for wear and secure connections. DAILY
Remove the front cover. Check for debris and clean
with a dry cloth or small vacuum nozzle.
MONTHLY
Lubricate treadmill running deck EVERY 3 MONTHS
MAINTENANCE
1. Anyandallpartremovalorreplacementmustbeperformedbyaqualiedservicetechnician.
2. DO NOT use any equipment that is damaged and or has worn or broken parts.
Use only replacement parts supplied by your country’s local MATRIX dealer.
3. MAINTAIN LABELS AND NAMEPLATES: Do not remove labels for any reason. They contain
important information. If unreadable or missing, contact your MATRIX dealer for a replacement.
4. MAINTAIN ALL EQUIPMENT: Preventative maintenance is the key to
smooth operating equipment as well as keeping your liability to a
minimum. Equipment needs to be inspected at regular intervals.
5. Ensure that any person(s) making adjustments or performing maintenance
orrepairofanykindisqualiedtodoso.MATRIXdealerswillprovideservice
and maintenance training at our corporate facility upon request.
WARRANTY
For North America, please visit www.matrixtness.com for warranty
information along with warranty exclusions and limitations.
PRODUCT SPECIFICATIONS
Max User Weight 181.4 kg / 400 lbs
Product Weight 141.2 kg / 312 lbs
Shipping Weight 158.2 kg / 349 lbs
Overall Dimensions
(L x W x H)*
193 x 88 x 150 cm /
76” x 34.6” x 59”
Max. Harness Loading 136 kg / 300 lbs
* Ensure a minimum clearance width of 0.6 meters (24”) for access to and
passage around MATRIX equipment. Please note, 0.91 meters (36”) is the
ADA recommended clearance width for individuals in wheelchairs.
RUNNING
BELT
RUNNING
DECK
LUBRICATING THE RUNNING BELT
1. Using a T-wrench or Allen wrench, loosen the rear roller bolts
10-15 counter-clockwise turns. This should give
the belt enough slack for you to lift it.
2. Lift the belt as far as you can and squirt the silicone oil in a zigzag
pattern across the entire running deck surface. Use 30-50 ml of
100% silicone oil lubricant. Do not apply the silicone oil on top of
the running belt. Lay the running belt down and then tighten both
rear roller bolts clockwise the same number of turns loosened.
3. Walk on the machine at a comfortable speed for 3 minutes to spread the
silicone and to check the running belt for proper tension and alignment.
4. Wipe any excess oil from the sides with a damp cloth.
ENGLISH