9
STRENGTH: PREVENTIVE MAINTENANCE AND CLEANING CHECKLIST
Revision Date: December 2022
AURA: CABLE TENSIONING PROCEDURE
▶ Loosen the jam nut on the cable bolt above the weight stack
▶ Using your hand, pull any slack out of the cable and turn the cable bolt down removing the slack
▶ Once slack is removed, tighten the jam nut down using a wrench, finger tight is not good enough
▶ Insert weight stack pin into several different weight plates to ensure it goes in smoothly. If not, adjust cable tension back a bit until success
Note: On some machines, such as the cable Leg Press, there will be additional adjustment at the opposite side of the cable.
Only adjust there if you run out of bolt threads above the weight stack.
To Next Page
Loading...
