Need help?Do you have a question about the Matrix G7-S13-02 and is the answer not in the manual?
General| Weight Storage | No |
|---|---|
| Dimensions | 163 x 142 x 167 cm / 64" x 56" x 66" |
| Frame Finish | Powder-coated |
| Frame Color | Black |
| Adjustments | Yes |
Crucial safety guidelines for users and purchasers of exercise equipment.
Guidelines for stable base installation and securing equipment to prevent tipping.
Instructions for proper equipment maintenance, part replacement, and inspection intervals.
Information on supervised use, commercial environment suitability, and industry standards compliance.
Proper operating procedures, weight limits, and controlled exercise execution.
Specific torque values for bolts and nuts used in assembly and maintenance.
List of necessary tools for assembly and maintenance, including sizes.
List of hardware and components for the first assembly step.
List of hardware and components for the second assembly step.
List of hardware and components for the third assembly step.
List of hardware and components for the fourth assembly step.
List of hardware and components for the fifth assembly step.
Troubleshooting steps for blank or non-counting repetition displays.
Chart detailing sensor locations for different models related to repetition counting.
Diagnosing and fixing problems with a loose or sloppy incremental weight pin.
Solutions for when the weight stack pin cannot be inserted into weight plates.
Troubleshooting steps for weight stack cables falling off pulleys or cams.
Solutions for a missing or detached repetition counter magnet.
How to resolve issues where the adjustable handle does not move freely.
Procedures to test the machine after installing a replacement part.
Step-by-step guide for removing and replacing the top cover of the weight stack.
Instructions for removing and installing a new repetition counter.
Steps to remove and replace the side covers of the weight stack frame.
Guide for replacing the repetition sensors.
Detailed instructions for replacing the incremental weight pin.
Procedures for removing and installing individual weight plates.
Instructions for removing and replacing the weight stack pulley.
Steps to replace the head, seat, and back pads.
Guide for removing and installing a new adjustable handle.
Instructions for replacing the connection rod, including spring installation.
To Next Page
