Matrix TOUCH - Page 108

PARTS REPLACEMENT & INFORMATION
Table of Contents
Touch / TouchXL Console
108
Troubleshooting Guide
RFID Antenna
The RFID Antenna is located under the icon on the console front plastic panel. Swiping an RFID tag there
allows the console to read it for xID login or other functions.
This antenna is also used for GymKit login.
Follow these steps to replace this part.
1. Remove the Console upper rear shroud.
2. Remove the Fan Bracket.
3. Remove the two #2 Phillips screws securing the plastic antenna board support.
4. Lift the antenna board away from the console and disconnect the antenna wire from the socket.
5. Install the antenna by connecting the antenna wire to the socket and placing the board within
its tabs in the console.
6. Secure the support plate with two #2 Phillips screws.
7. Install the Fan Bracket.
8. Install the Console upper rear shroud.
TouchXL reference: 2
Touch reference: 2
Console photo index: 11a (Touch or TouchXL)
RFID Board
The RFID Board enables communication with enabled RFID devices for user login.
Follow these steps to replace this part.
1. Remove the Console upper rear shroud.
2. Remove the Fan Bracket.
3. Remove 2 #2 Phillips from the UCB bosses.