8
Chapter 2, Installing Your Matrox CompressHD Hardware and Software
Updating your CompressHD firmware
When you install Matrox Mtx.utils on a computer that has the CompressHD card
installed, the Mtx.utils Setup program automatically verifies the firmware on
your CompressHD card and updates it if required. If you install Mtx.utils on a
computer without the CompressHD card, the next time you start your computer
with CompressHD installed, Mtx.utils Setup will update your CompressHD
card’s firmware if needed.
²Caution Do not power off your computer, or interrupt the firmware update
during the update process. Doing so may damage your CompressHD card.
Note about using sleep and hibernation modes
with CompressHD
Before setting your computer to sleep or hibernation mode, make sure that you
first quit any application that is using your CompressHD hardware, such as
Adobe Media Encoder.
Removing your Matrox CompressHD software
To remove Matrox Mtx.utils from your computer, choose Start > All Programs
> Matrox Mtx.utils > Uninstall Matrox Mtx.utils
.
To Next Page
Loading...
