30 Matrox TripleHead2Go – User Guide
Installing your Matrox PowerDesk software
Insert the Matrox CD-ROM in your CD-ROM drive, then follow the on-screen instructions.
Running the Matrox setup wizard
Run the setup wizard to guide you step-by-step through the process of setting up your
Matrox product. The setup wizard launches automatically after you install your PowerDesk
software. To configure a new product, select
Set up a new Matrox product
, then follow the
on-screen instructions.
If the setup wizard doesn’t launch automatically, you can start it manually by clicking
Start
Æ
All programs
Æ
Matrox Graphics
Æ
Start setup wizard
.
Note:
Windows 2000
– If you’re using a laptop computer, make sure your TripleHead2Go
product is set as your primary display and your computer’s flat panel monitor is set as your
secondary display before installing your Matrox software. Otherwise, your Matrox
software won’t install. For more information on enabling your displays, see your graphics
hardware documentation.
Note:
The Matrox setup wizard is available only on TripleHead2Go Digital Edition and
TripleHead2Go DP Edition products.
To Next Page