PM Control by APM Default: Yes
Windows 95 and 98 have built-in power management capabilities called APM
(advanced power management). When you enable this item, you allow the APM
routines in Windows to operate on your system.
Video Off Option Default: Suspend -> Off
This option defines which level of power-saving mode is required in order to
power down the video display. As a default, the video powers down in suspend
mode but not standby mode.
Video Off Method Default: DPMS Support
This item defines how the video is powered down to save power. As a default,
this is set to DPMS Support (display power management software).
Modem Use IRQ Default: 3
If you would like an incoming call on a modem to automatically resume the
system from suspend mode, use this item to specify the interrupt request line
(IRQ) that is used by the modem.
Soft-Off by PWRBTN Default: Instant-Off
Under ACPI (advanced configuration and power interface) the system can be
turned off mechanically (by the power button) or it can undergo a software power
off. If the system has been turned off by software, the system can be resumed by
a LAN, MODEM or ALARM wake up signal. This item allows you to define a
software power off using the power button. If the value is set to Instant-Off, the
power button will automatically cause a software power off. If the value is set to
Delay 4 Sec. the power button must be held down for a full four seconds to
cause a software power off.
HDD Power Down Default: Disabled
You can use this item to set a timeout for a hard disk powerdown. You can set a
time from 1 to 15 minutes. If the hard disk is inactive for the time specified, it will
power down. It will automatically return to full power when it is next accessed.
Doze Mode Default: Disabled
If you have selected User Define for the Power Management item, you can set
this item to a selection of timeouts from 20 seconds to 40 minutes.
Suspend Mode Default: Disabled
If you have selected User Define for the Power Management item, you can set
this item to a selection of timeouts from 20 seconds to 40 minutes.
VGA Default: OFF
When this item is enabled, any activity on the graphics system can reset power-
saving mode timeouts to zero, or resume the system from a power saving mode.
LPT & COM Default: LPT/COM
When this item is enabled, it defines system activities which can reset power-
saving mode timeouts to zero, or resume the system from a power saving mode.
This item is for transmissions through the serial or parallel ports.
To Next Page
Loading...
