Modem Driver and Software
1. In the BIOS system setup utility
2. In the “Chipset Features Setup” of the system setup utility
3. Enable the item “On Board Modem”
Install the Modem driver from the sub-folders for Windows 95/98 or
Windows NT4.0.
Windows 95/98
The modem is a plug and play device so Windows 95/98 will
automatically detect the presence of your modem. When the Plug and
Play wizard begins to look for modem drivers, click on the button that
says Have Disk and then browse or type in the pathname to the
CMI8x58\modem\win9x folder.
Windows NT 4.0
Follow the instructions in the README file in the WINNT4 sub-folder.
VIA Folder Installation Notes
The setup program supports to register VIA chipset’s function in
Windows 95 and Windows 98.
Installation procedure:
1. Run setup and select “ install VIA Chipset Functions ‘Registry’”,
then it will automatically install this program.
2. You can see that it displays “VIA Power Management Controller”
and “VIA PCI to USB Universal Host Controller”
Note: If user want to upgrade Windows 95 to Windows 95 OSR
2.1(4.00.950 B), it’s necessary to remove USB from other device.
IDE Bus Master Driver
The IDE Bus Master Drivers are stored in a folder named IDE.
Windows 95/98 Installation
1. Click the Windows Start button, and then click on Run.
2. Browse to the folder IDE and select the program called SETUP.EXE.
3. Click on the Install button on the setup screen.
4. Follow the instructions on the screen to complete the installation of
the Bus Mastering IDE drivers.
To Next Page
Loading...
