Windows NT Installation
1. Carry out the installation instructions for Windows 95/98 steps 1 to 4.
2. In the Control Panel, select the icon SCSI adapters.
3. Select the Add button on the drivers sheet.
4. Select the item “VIA Bus Master PCI IDE Driver” and click OK.
5. Reboot the system.
Installing the IRQ Routing Driver
This driver is for Windows 95/98. This driver solves some issues regarding the
IRQ assignment of PCI devices.
Windows 95 Installation
1. Click the Windows Start button, and then click on Run.
2. Browse to the correct folder and select the program called
SETUP.EXE.
3. Follow the instructions on the screen to complete the installation.
Windows 98 Installation
1. In the Integrated Peripherals page of the system setup utility, enable
the item OnChip USB.
2. In the PNP/PCI Configuration page of the system setup utility,
enable the item Assign IRQ for USB.
3. Restart the system and continue with steps 1, 2, and 3 of the
Windows 95 installation instructions.
VxD Drivers
The VxD driver provides support for an AGP graphics adapter. You only
need to install this driver if you are running Windows 95, and you have
installed the mainboard with an AGP graphics adapter. The VIA VxD
driver is for use in Windows 95 version OSR 2.1 (4.00.950 B) or later.
Windows 95 Installation
You need the following files installed on your system before beginning
the installation:
1. Get the file "USBSUPP.EXE" from Microsoft, which includes the
USB supplement and a new memory manager (VMM32.VxD)
needed for the AGP DIME (Direct Memory Execute) feature.
2. Get DirectX 5.0 from Microsoft. DirectX 5.0 is the first DirectX
version that supports AGP's DIME.
To Next Page
Loading...
