Calder Brothers Corporation
Model: M415XT Maintainer
M415XT
Section C – Controls & Accessories
Loader Mode
Boom Lift
Pull Joystick BACK (Y Axis) to raise the Front End Loader Boom. Push Joystick FORWARD (Y Axis) to
lower the Boom.
Bucket Tilt
Pull Joystick RIGHT (X Axis) to tilt the Loader Bucket back. Move Joystick LEFT (X Axis) to tilt the Bucket
forward.
Scarifier Lift
Tool Bar is used with the Scarifier and/or the compactor attachment. Move Slider (A) all the way in EITHER
direction THEN Move Slider (C) Up to Raise Scarifier or Down to lower the Scarifier.
Auxiliary Hydraulics
Auxiliary power is controlled using the Button ( E ) on the Joystick. This turns the auxiliary hydraulic power on and
off.
Grader Mode
Right/Left Blade Lift
Pull the Joystick directly BACK (Y Axis) to lift the Blade evenly. Push the Joystick FORWARD (Y Axis) to lower
blade evenly. If you PUSH the Joystick directly RIGHT (X Axis) the Right Side of the blade will go DOWN and the
LEFT side with go UP. PULL the Joystick Directly LEFT (X Axis) the Left side of the blade will go DOWN and the
RIGHT side will go UP.
Blade Tilt
The Moldboard may be tilted forward or backward up to 45°. Move Slider (C) FORWARD to tilt the
Blade forward. Pull Slider (C) BACK to tilt the Blade backward.
Blade Side Shift
The Moldboard may be extended to the right or left up to 36” (0.9m) each way. Move Slider (A) on the Joystick
RIGHT to shift the Blade to the right. Pull Slider (A) LEFT to shift the Blade to the left.
Blade Angle
Move Slider (D) FORWARD on the Joystick to pivot the Moldboard counter-clockwise (left angle position). Pull
Slider (D) BACK to extend the Moldboard clockwise (right angle position).
To Next Page
Loading...