Maven RF Series - Reticle and Unit of Measure Settings; Degree of Angle Display; Changing Aiming Reticle; Unit of Measure Selection

ADJUSTING DISPLAY BRIGHTNESS:
With the unit on, rotate the Menu Dial clockwise to decrease brightness and
counterclockwise to increase brightness (in the menu this displays as BR1-5).
ANGLE MODE:
The RF.1 provides you the ability to measure and display either Line of Sight (LOS) or
Angle Compensated distance (COMP). Angle compensated distance is an automatic
calculation using the line of sight distance and factors in the degree of elevation
angle.
When in Line of Sight Mode and unit is on: “LOS” indicator will be visible in bottom
of display.
When in Angle Compensation Mode and unit is on: “COMP” indicator will be visible in
bottom of display.
To change Angle Mode:
With RF.1 on, press the MENU/ ENTER button. The current Mode will be displayed at
the top of the display as either ANGLE COMPENSATED or LINE OF SIGHT.
To change, rotate the MENU Dial until the desired mode is displayed and then press
the MENU /ENTER button.
Exit by pressing the FIRE button. Angle Mode selected will be displayed within bottom
of display as “LOS” or “COMP”.
DEGREE OF ANGLE:
Displays from -90 to +90 degrees. This indicator will only display angle in Line of
Sight mode.
AIMING RETICLE:
Choose from four reticle options (Diamond, Crosshair, Dot, and Crosshair with
Diamond).
To change Reticle:
With RF.1 on, press the MENU / ENTER button and continue doing so until the current
reticle is displayed.
To change, rotate the Menu Dial until the desired reticle is displayed and then press
the MENU / ENTER button.
Exit by pressing the FIRE button
UNIT OF MEASURE:
The RF.1 provides distance measurements in yards or meters.
To change unit of measure:
With RF.1 on, press the MENU / ENTER button and cycle through until the current Unit
of Measure is displayed.
-continued on next page
To change, rotate the Menu Dial until the desired unit of measure is displayed and
then press the MENU / ENTER button. Exit by pressing the FIRE button.
FIELD / FOREST LEVER:
This lever allows you to easily and quickly select for your application and
environmental setting.
Field – Move the lever to “Field” when you want to acquire small, hard to hit targets
and ignore larger objects in the background (e.g. target in front of trees). Displayed
as FLD.
Forest – Move the lever to “Forest” when you want to acquire distance to objects
located behind trees, bushes, or thicket; or when in rainy or snowy conditions (e.g.
target behind cover). Displayed as FOR.
SCAN INDICATOR:
With the laser on, press and hold the FIRE button, scan back and forth to various objects;
while doing so, watch for changes in the measurement number displayed as you move
the aiming reticle across targeted objects. This is a quick way to get an accurate
reading on multiple objects. This will be indicated as SCAN within the display.
BATTERY LIFE INDICATOR:
Within the display, the Battery Life Indicator shows how much battery charge is
remaining. The Battery Indicator will display the first time POWER button is pressed
and will also display in the MENU. If Battery Indicator blinks - battery needs to be
replaced and the unit will not be operable.