Mavic Wintech USB - Page 15

14
14.5. Lap time data review
Enter the elevation set up and data review menu: From any screen, press the left button for 2 seconds.
– On Wintech USB Alti and Wintech USB Ultimate, briey press the left button (BPL) 3 times to switch to the lap time data review section: “Cr” appears on the computer screen.
– On Wintech USB HR, briey press the left button (BPL) once to switch to the lap time data review section: “Cr” appears on the computer screen.
– On Wintech USB “Cr” appears on the computer screen.
Briey press the right button (BPR) to enter the lap time data review section.
The review of the rst lap time automatically starts in the following order:
– Elapsed time in the rst lap time
– Distance ridden during the lap time
– Average speed during the lap time
– Average vertical speed during the lap time (Wintech USB Alti and Wintech USB Ultimate only)
– Average slope in % during the lap time (Wintech USB Alti and Wintech USB Ultimate only)
Each piece of information is displayed for 3 seconds.
If no lap time has been recorded during the trip, it is not possible to enter the lap time data review section
when briey pressing the right button on the “Info” screen.
At any time of the sequence, briey press the left button (BPL) to switch to the next lap time.
These data will cycle through until you press and hold the left button for 2 seconds. Then, the computer switches back to the last active screen.
If no button is pressed for 2 minutes, the computer automatically switches back to the last active screen.
14.5
2 sec.
Alti
Ultimate
USB
HR
3 click
1 click
1 click
after
3 sec
auto
1 click 1 click 1 click 1 click 1 click
next CR next CR next CR next CR next CR
after
3 sec
auto
after
3 sec
auto
after
3 sec
auto
after
3 sec
auto
any
screen
2 sec 2 sec 2 sec 2 sec 2 sec
EXIT EXIT EXIT EXIT EXIT