max mobility SmartDrive MX2 - Page 14

5425 crossings boulevard, nashville, tn 37013 usa • p: 800.637.2980 • f: 888.411.9027 • www.max-mobility.com
It is important for your safety and the safety of those around you that you are properly trained to use the SmartDrive.
Please take this training seriously and be sure to ll-in all information. If you do not understand something, just ask.
SmartDrives are shipped in training mode to allow for familiarity and wristband deactivation practice prior to extensive use.
Training mode is indicated by green LED indication on the wristband.
ere are instructional videos available at www.max-mobility.com that are very helpful in learning all about your Smart-
Drive [use the Closed-Captions for subtitles in other languages].
1) Read the SmartDrive User’s Manual. Please heed all of the warnings in yellow, as this information is important for your
safety. Pay close attention to situations where it is safest to turn the SmartDrive OFF.
2) Demonstrate each of the skills to your dealer and check them o once you are condent with each skill:
Install the wristband onto your wrist. Understanding that the wristband should be OFF whenever handling the
drive unit [or transfering into / out of your chair], turn the drive unit on and install it onto your wheelchair.
Turn the wristband on and allow for it to wirelessly connect to the drive unit.
Before pushing, practice tapping your hand against your handrims with a sti wrist. You will see the wristband
LED go red if it’s a good tap. Continue to practice this tap until you get it every time.
Push slow to go and tap then brake to stop.
Push slow to go slow, then push faster to go fast, and then tap brake to stop.
Once you have perfected the tapping motion needed by the wristband to deactivate the motor, it’s time to switch to normal
operation to get the most our of your SmartDrive in all the environments encountered on a daily basis. To do this, just press
and hold the button on the wristband for ve (5) seconds, at which point you will feel a vibration and see the wristband LED
change to blue; then release the button.
While in normal operation - push to go, turn in a gure 8, and then tap brake stop.
3) Sign this form below, scan and e-mail it to training@max-mobility.com or fax it to (888) 411-9027.
SmartDrive Serial Number: _______________________________________ Date: ___________________
Client
I certify that I have read the User’s Manual and demonstrated the skills checked above. I accept that the SmartDrive can
be dangerous if not used carefully and I take responsibility for making responsible driving choices while using it. I under-
stand there are many situations where the SmartDrive should be turned OFF to prevent it from unintentionally powering
forward, including: downhill slopes, up or down curbs, climbing large sidewalk cracks, while in conned spaces, before
handling the drive unit and transferring into and out of my wheelchair.
Name: _____________________________________ Signature: _____________________________________
Dealer
I have observed the client performing the skills checked above.
Name: _____________________________________ Signature: _____________________________________
SmartDrive MX2
Training Certication
CUT OR TEAR HERE IF NEEDED
MUST be completed and returned...failure to comply will restrict future orders.