MAXA MI Series - Page 19

Hydronic Highwall
18 Installation
13.2 Accessory
Name Shape Quantity Function
1. Screw ST3.9x25 for installation board 3 Secure the installation board
2. Plastic expanded tube 3
3. Wrapping tape 1
4. Drain pipe 1
5. Wall conduit cover
1
6. Remote controller
(including operation manual)
1
7. Frame
1 Hold the remote controller
8. Mounting screw (ST2.9 x 10-C-H) 2 Insulation the holder of remote controller
9. Alkaline dry batteries (AM4)
2
10. Owner's manual
1
11. Installation manual
1
12. seel gasket 4 For connecting water pipe
13.3 Remote controller installation
 Never throw or beat the controller.
 Before installation, operate the remote controller to determine its location in a reception range.
 Keep the remote controller at least 1m apart from the nearest TV set or stereoequipment. (it is necessary
to prevent image disturbances or noise interferences.)
 Do not install the remote controller in a place exposed to direct sunlight or close to a heating source,
such as a stove.
 Note that the positive and negative poles are right positions when loading batteries.
 This information is subject to changes due to technological improvement without further notices.