MAXA MI26A User Manual (English)

Questions and Answers:

K
Kenneth AbbottAug 4, 2025
Why is my MAXA MI26A Air Conditioner not cooling well?
- V
  victoriagonzalezAug 5, 2025
  If your MAXA Air Conditioner isn't cooling effectively, several factors could be at play. First, check if the outdoor and indoor unit heat exchangers are dirty and clean them if necessary. Also, ensure the air filter is clean. Make sure that the inlet and outlet of the indoor and outdoor units are not blocked, removing any obstructions to ensure smooth airflow. Verify that all doors and windows are closed to prevent heat from entering. If sunlight is shining directly into the room, use curtains to block it. Reduce any excessive heat sources in the room. Finally, keep in mind that if the outdoor temperature is very high, the air conditioner's cooling capacity may be reduced, which is normal.
J
Jason LeonardAug 11, 2025
How to fix a MAXA MI26A that won't turn on?
- O
  ojonesAug 11, 2025
  If your MAXA Air Conditioner unit doesn't start, it could be due to a few reasons. There might be a power failure, so wait for the power to return. Check if the power switch is off and turn it on. The fuse of the power switch might have burned out, requiring replacement. Also, the batteries in the remote controller might be exhausted, or there could be another issue with the controller, so try replacing the batteries or checking the controller.
W
William MartinezAug 19, 2025
What to do if my MAXA MI26A Air Conditioner is leaking water?
- Y
  yfarleyAug 20, 2025
  If water is flowing out from your MAXA Air Conditioner unit, several issues could be the cause. The water in the drainpipe might be too cold, leading to condensation, in which case you should pack the drainpipe with insulation cotton. The drainpipe could be clogged or broken, requiring cleaning or replacement. Ensure the connection of the inlet/outlet pipe is secure. If the drainpipe outlet is too high, causing water to exit from the condensate collecting plate, lower the drainpipe outlet below the unit’s bottom. Finally, check if the unit is heavily inclined and, if so, place it horizontally.