Maxell MXSP-BT03 - Charging in Power OFF Mode; Battery Note and Care; Battery Safety Precautions; Charging Safety Guidelines

4
to keep the internal battery working properly.
Charging in Unit Power OFF mode
 The Indicator LED is RED while charging.
 The Indicator LED will change from RED to BLUE when the battery is fully charged.
Battery Note and Care
Do not burn or bury batteries.
 Do not puncture or crush.
 Do not disassemble.
 Li-ion batteries must be recycled. Do not dispose of in the trash.
 Use only chargers rated for Li-ion cells. Be sure the charger’s voltage and current settings are correct for
the battery pack being charged.
 Charge batteries on a fireproof surface and away from flammable items or liquids.
 Batteries should NEVER be left unattended while charging. Only adults should charge the batteries.
 Follow the manufacturer’s instructions for charging the product and do not charge longer than
recommended. Unplug the charger when the battery is charged or not in use.
NOTE: The speaker is not magnetically shielded and may cause color distortion on the screen of some TVs or
video monitors. To avoid this, you may need to move the unit further away from the TV or monitor if an unnatural
color shifts or image distortion occurs.
CARE AND MAINTENANCE
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or
motors.
CLEANING THE UNIT
 To prevent fire or shock hazard, disconnect your unit from the USB port of power source when cleaning.
 The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use caution when
cleaning and wiping the plastic parts.
 If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish sprays on the
cabinet.
 If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth slightly
dampened with a mild soap and water solution. Never use abrasive cloths or polishes as these will damage
the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
TROUBLESHOOTING GUIDE
Symptom
Possible Problem
Solution
No Charging
The USB power adaptor (not
included) is not plugged into a
wall outlet or the USB cable
(included) is not plugged into the
micro USB jack on the bottom of
the MXSP-BT03.
Plug the USB power adaptor (not included) into a wall
outlet and plug the USB cable (included) into the
micro USB jack on the the MXSP-BT03.
Wall outlet is not functioning.
Plug another device into the same outlet to confirm
the outlet is working.
Computer USB port is not
functioning.
Make sure your computer power is turned on and try
another USB port.
No Sound
The MXSP-BT03 battery is dead. Recharge the MXSP-BT03 battery.
The MXSP-BT03 is not linked
with the mobile phone.
Go through “Speaker Operations” process to link the
speaker.
The MXSP-BT03 placement is
out of range.
Relocate the MXSP-BT03 within Bluetooth operating
range (30 feet).
Volume set too low. Increase the volume of your device.
Sound is
distorted.
Volume level is set too high. Decrease the volume of your device.
Sound source is distorted.
If the source sound file is of poor quality, distortion and
noise are easily noticed with high-power speakers. Try
a different audio source such as a music CD.
Unit gets warm
after extended
play at high
volume.
This is normal.
Turn the unit off for a period of time or lower the
volume.