1. Check that the cylinder valve is closed by turning the knob clockwise. Inspect cylinder valve rubber
seal for cracks or deterioration. Do not use propane tank with damaged seal as a gas leak may occur.
2. Place the cylinder into the notches of the tank holder on the bottom of right legs.
3. Orient the cylinder such that the valve opening faces the right side of the grill, and the hose is not
kinked or damaged. Then slide tank brace over cylinder handle and secure tightly.
• Inspectthepropanetankvalverubbersealforcracks,
wear or deterioration prior to use. A damaged rubber
seal can cause a gas leak, possibly resulting in an
explosion, re or severe bodily harm.
• Inspectionshouldbedoneeachtimethepropanetank
is connected to the grill, has been relled, exchanged or
has not been used for more than 60 days.
• Donotuseapropanetankwithadamagedrubberseal.
Exchange the tank or have the rubber seal replaced at a
qualied propane lling station.
6
Good
Rubber Seal
Damaged
Rubber Seal
Tank Support
Bracket
Tank Support Bracket
Tank Heat
Shield
Tank Brace
HOSE & REGULATOR SPECIFICATIONS AND INSTALLATION:
source such as a natural gas line.
DO NOT use any other pressure regulator/hose assembly other than the one supplied with your
DO NOT attempt to adjust or repair a regulator. The regulator is designed to operate at a
CLOSED prior to connecting the LP gas cylinder to your grill. Turn the
valve knob clockwise to properly close the valve. Read and follow all instructions and warnings
on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe
use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read
and follow all warnings on the LP cylinder.
WARNING
To Next Page
Loading...