EasyManua.ls Logo

Maxfire Torch - User Manual

Maxfire Torch
55 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER’S MANUAL / MANUAL DEL PROPIETARIO
WARNING/ADVERTENCIA
HAZARDOUS EXPLOSION MAY RESULT IF THESE WARNINGS AND INSTRUCTIONS
ARE IGNORED. READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS IN THIS
MANUAL TO AVOID PERSONAL INJURY, INCLUDING DEATH OR PROPERTY DAMAGE.
SE PUEDE PRODUCIR UNA EXPLOSIÓN PELIGROSA SI SE HACE CASO OMISO A
ESTAS ADVERTENCIAS E INSTRUCCIONES. LEA Y SIGA TODAS LAS ADVERTENCIAS
E INSTRUCCIONES EN ESTE MANUAL PARA EVITAR LESIONES PERSONALES,
INCLUSO LA MUERTE, O LOS DAÑOS MATERIALES.
ASSEMBLY AND OPERATING IN STRUC TIONS
INSTRUCCIONES DE ARMADO Y OPERACIÓN
SAVE THIS MANUAL FOR FUTURE REFERENCE
GUARDE ESTE MANUAL PARA REFERENCIA FUTURA
NOTICE TO INSTALLER:
LEAVE THESE INSTRUCTIONS
WITH THE GRILL OWNER FOR
FUTURE REFERENCE .
AVISO PARA EL
INSTALADOR:
ENTREGUE ESTAS
INSTRUCCIONES AL
PROPIETARIO DE LA PARRILLA
PARA REFERENCIA FUTURA.
2 Burner Gas Grill
Parrilla a Gas de 2 Quemadores
Torch
™

Table of Contents

Questions and Answers

  • H
    Hannah MaldonadoAug 18, 2025
    Why is my Maxfire Grill not getting hot enough?
    • E
      Erik CohenAug 18, 2025
      If your Maxfire Grill isn't getting hot enough, start by checking if the LP gas tank is empty and replace or refill if necessary. Another possible cause is the activation of the flow limiting device. To resolve this, try a Mini Reset: turn control knobs and the LP gas tank valve to “OFF”, wait one minute, and relight the grill per the “Lighting Instructions”. If the flames are still too low, perform a Full Reset: turn control knobs and the LP gas tank valve to “OFF”, disconnect the regulator from the propane tank, inspect the LP cylinder rubber seal, wait 1 minute, reconnect the regulator, perform “Leak Testing” on all connections, and then light the grill per the “Lighting Instructions”.
  • J
    Julie VargasAug 21, 2025
    What to do if my Maxfire Torch has flare-ups?
    • T
      Travis MillerAug 21, 2025
      Flare-ups on your Maxfire Grill can occur due to several reasons. One common cause is grease buildup; clean all grill parts according to the “Proper Care and Maintenance” instructions. Another reason could be excess fat in the meat, so trim the fat before grilling. Finally, excessive cooking temperature can also cause flare-ups, so adjust the cooking temperature to a lower setting.
  • K
    Krystal LopezAug 25, 2025
    How to stop a grease fire in my Maxfire Grill?
    • A
      Amber SullivanAug 26, 2025
      If you experience a grease fire in your Maxfire Grill, the cause may be grease trapped by food buildup around the burner system. To address this: 1. Turn control knobs and LP gas tank valve to “OFF”. 2. Leave the lid in open or closed position and let the fire burn out. Use a BC type fire extinguisher or baking soda, sand, or dirt to smother the fire if necessary. 3. After the grill cools, remove and clean all parts per “Proper Care and Maintenance” instructions.
  • M
    Mrs. Natalie AdamsAug 28, 2025
    Why does my Maxfire Torch Grill have an irregular flame pattern?
    • A
      Adam KnightAug 28, 2025
      An irregular flame pattern on your Maxfire Grill, where the flame doesn't run the full length of the burner, can be caused by clogged or blocked burner ports. Clean the burner ports to resolve this issue. Another potential cause is that the air shutter on the burner needs adjustment; refer to the section on “Burner Adjustment”.
  • M
    Mr. Mark TuckerSep 1, 2025
    What to do if the flame keeps blowing out on my Maxfire Grill?
    • D
      Desiree GallegosSep 1, 2025
      If the flame on your Maxfire Grill blows out, it could be due to high or gusting winds; avoid using the grill in these conditions. Another cause might be low LP gas, so replace or refill the LP gas tank. Additionally, burner holes may be obstructed; refer to the “Burner Assembly/Maintenance” instructions. A tripped flow limiting device could also be the reason; refer to the “Regulator Resetting Procedure”.
  • A
    Anna ThompsonSep 4, 2025
    Why is the flame on my Maxfire Grill yellow or orange?
    • L
      Lisa WiseSep 4, 2025
      A yellow or orange flame on your Maxfire Grill can occur for several reasons. If it's a new burner, it may have residual manufacturing oils; burn the grill for 15 minutes on “HIGH” with the lid closed. Another cause could be spider webs or insect nests in the venturi, so clean the venturi and burner assembly. Food residue or grease can also cause this issue; clean the burner assembly. Finally, poor alignment of the valve to the burner venturi can be the problem; ensure the burner venturi is properly engaged with the valve. See the section on “Burner Adjustment”.
  • B
    bethany10Sep 7, 2025
    What causes flashback or melting knobs on my Maxfire Torch Grill?
    • A
      Amanda AndersonSep 7, 2025
      If you experience flashback (fire in burner tubes) or melting knobs on your Maxfire Grill, it's likely that the burner and/or burner tubes are blocked. Clean the burners and/or burner assembly to resolve this issue.
  • A
    Allison BurnsSep 12, 2025
    Why is the inside of my Maxfire Grill lid peeling?
    • W
      woodwardrobertSep 12, 2025
      If the inside of your Maxfire Grill lid is peeling, resembling paint peeling, it's likely due to baked-on grease buildup that has turned into carbon and is flaking off. Clean the grill thoroughly per the “Proper Care and Maintenance” instructions.
  • S
    suttondonaldNov 14, 2025
    How to fix a Maxfire Torch Grill burner that won't light?
    • K
      Katie BakerNov 14, 2025
      If the burner on your Maxfire Grill won't light, there are several potential causes. First, ensure the LP gas tank valve is open and the regulator is securely attached. Also, check if the LP gas tank is low or empty, and replace or refill it if needed. If there's a gas leak, turn the LP gas tank valve to “CLOSED”, wait 5 minutes, and follow the “Leak Testing” instructions. Other possible causes include a disconnected coupling nut and regulator, obstruction of gas flow (clean burner assembly or check for bent/kinked hose), improperly seated burner (reseat burner and valve), spider webs or insect nest in venturi (clean venturi and burner assembly), clogged or blocked burner ports (clean burner ports), a dead battery (replace the battery), cooking residue on wires or electrode (clean with rub...

Summary

Important Safety Warnings

DANGER: If you smell gas

Steps to take if you detect a gas leak, including shutting off supply and extinguishing flames.

WARNING: Flammable liquids and vapors

Prohibition of storing or using flammable liquids or vapors near the grill.

DANGER: Spare LP cylinder storage

Rules for storing spare LP cylinders, including not storing under or near the grill and proper filling.

General Warnings

LP Gas Cylinder (Tank) Specifications and Installation

Details on the required specifications for LP gas cylinders and their proper installation.

Hose & Regulator Specifications and Installation

Information on the specifications and installation procedures for the grill's hose and regulator assembly.

General Warnings

Grill Operation Warnings

Crucial warnings regarding grill operation, including safe distances, ventilation, and avoiding misuse.

Outdoor Use and Placement

Guidelines for positioning the grill outdoors safely, including clearances from combustible materials and structures.

LP Gas Cylinder (Tank) Specifications and Installation

Cylinder Valve and Connection

Details on connecting the grill to a Type 1 cylinder valve and specifications for the propane tank.

LP Cylinder Storage and Handling

Warnings and instructions for storing and handling LP gas cylinders, including prohibitions on storage near the grill.

Filling the LP Gas Cylinder (Tank)

Proper Filling Procedures

Instructions for safely filling LP gas cylinders, emphasizing qualified dealers and the 80% capacity limit.

Hose & Regulator Specifications and Installation

Hose & Regulator Connection

Steps for connecting the hose and regulator to the LP gas cylinder and grill, including safety checks.

LP Gas Cylinder (Tank) Rubber Seal Inspection

Procedures for inspecting the rubber seal on the LP gas cylinder valve for damage.

Leak Testing

Leak Test Procedure

Step-by-step guide on how to perform a leak test on gas connections using soapy water.

Regulator Resetting Procedure

Instructions on how to reset the regulator if the grill is not heating properly.

Checking for Leaks

Performing a Leak Test

Detailed instructions for performing leak tests on gas connections, including safety precautions.

Pre-Start Check List

Lighting Instructions

General instructions and warnings before attempting to light the grill.

Lighting the Main Burners

Step-by-step guide for lighting the main burners using the igniter.

Operating the Grill

Match Lighting the Main Burners

Instructions for lighting the main burners using a match if the igniter fails.

Controlling Flare-Ups;Grease Fires

Turning Off the Grill

Procedures for safely turning off the grill, including shutting off the cylinder valve and control knobs.

Proper Care & Maintenance

Cleaning Interior of Grill

Guidelines for cleaning the interior components of the grill, including grates and heat tents.

Maintaining Exterior of Grill

Instructions for cleaning and maintaining the exterior surfaces of the grill to prevent rust and damage.

Burner Cleaning and Maintenance

Procedures for cleaning and maintaining the grill burners for optimal performance and safety.

Burner Assembly;Maintenance

Burner Cleaning Steps

Detailed steps for cleaning and inspecting grill burners, including removing debris and checking for damage.

Burner Adjustment

Transporting and Storage

Safety guidelines and instructions for transporting and storing the gas grill.

Trouble Shooting

Burner Issues

Common problems related to burners not lighting or having irregular flame patterns and their solutions.

Grill Heating Issues

Troubleshooting steps for when the grill does not heat up sufficiently, including flow limiting device activation.

Grill Cooking Tips

Grilling to Proper Temperature

Recommended internal temperatures for various foods to ensure safe consumption.

Assembly Instructions

Component Card Contents

List of components included in the assembly kit, detailing quantities and types of hardware.

Parts List

Required Tools

List of tools necessary for assembling the Maxfire Torch 2 Burner Gas Grill.

Warranty

Maxfire Torch Specifications

General IconGeneral
BrandMaxfire
ModelTorch
CategoryGrill
LanguageEnglish