Maxfire Torch - Checking for Leaks; Performing a Leak Test

8

• Afterassemblingyourgrillandbeforelightingforthersttime,evenifpurchasedfullyassembled.
• EverytimetheLPgascylinderisrelled,exchangedorifanyofthegascomponentsaredisconnectedor
replaced.
• Anytimeyourgrillhasbeenmoved.
• Atleastonceperyearorifyourgrillhasnotbeenusedformorethan60days.

CAUTION: Strong odors, colds, sinus congestion, etc. may prevent the detection of propane by smell.
Use caution and common sense when testing for leaks.
Note: The leak test must be performed in an area that has adequate lighting in order to see if bubbles are
developing and not in a windy or noisy area so larger leaks can be detected by smell or sound.
1. Create a mixture of 50% water and 50% liquid dishwashing soap.
2. Open the lid.
3. Ensure all control knobs are set to the “OFF” position.
4. Turn on the gas at the cylinder valve. Turn the cylinder valve knob counter-
clockwise to full open. If you hear a rushing sound or smell gas, turn the gas
off. Tighten any leaking connections. If leak is detected at connection nut and
tightening does not stop leak, reinspect propane tank rubber seal.
5. Apply the soapy water mixture to the following:
Supply tank (cylinder) welds.
Connection nut to tank valve.
Back side of connection nut to brass nipple.
Brass nipple connection into regulator.
Regulator connections to gas supply hoses.
Hose connection to gas manifold.
The full length of gas supply hose.
Tank valve to cylinder.
6. Checkeachplacelisted(A–H)forgrowingbubbles,which
indicates a leak. Large leaks may not be detected by bubbles but
should produce a rushing sound or gas smell.
7. Turn off gas supply at cylinder valve.
8. Turn on control knobs to release gas pressure in hose.
9. Turn control knobs to “OFF” position.
10. Tighten any leaking connections. If leak is detected at connection nut and tightening does not stop leak, reinspect
propane tank rubber seal. (see page 6)
11. Repeat soapy water test until no leaks are detected.
12. Turn off gas supply at cylinder valve until you are ready to use your grill.
13. Wash off soapy residue with cold water and towel dry.
14. Wait 5 minutes to allow all gas to evacuate the area before lighting grill.
WARNING: DO NOT use the grill if leaks cannot be stopped. Contact a qualied gas appliance repair service.
To prevent re or explosion hazard:
  DO NOT smoke or permit ignition sources in the area while conducting a leak test.
  
  
  
A
B
C
D
E
F
G
H
Watch For Bub bles
DANGER
A
B
C
D
E
F
G
H