19
Battery Instructions
Charging Procedure
The MaxFoot battery can be charged on the bike or also can be removed and charged at a location away from the
E-bike.
1.Plug the charger into an AC outlet. The LED indication light should be green and red showing the charger is working
normally.
2.Then plug the charger into the charging port located on the side of the battery by sliding open the charger cover on
the battery. Charging should initiate and will be indicated by the LED charge status lights on the charger turning red.
3.Once fully charged, indicated by charging indicator light turning green and red, unplug the charger from the outlet
first and then remove the charger output plug from the battery charging port.
4.Ensure the battery and charger are not damaged before initiating charge.
If you notice anything unusual while charging, please discontinue charging and use of the bike and contact us via this
email: support@maxfoot.bike.
Battery Charging Information
1.Check the charger, charger cables, and battery for damage before beginning each charge.
2.Avoid subjecting the battery to high temperatures, such as directly under the sun, for prolonged periods of
time. Always charge in a safe area that is cool, dry.
3.The battery does not have to be completely discharged before it is recharged. Completely discharging will
reduce the numbers of recharging cycles during the battery’s life and limit the capacity.
4.A Lithium battery has no “memory effect" and therefore can be charged at any time. It is perfectly acceptable
to recharge the battery after a short ride so that the battery is fully charged before the next ride.
5.Do not leave a charging battery unattended.
To Next Page
Loading...