29
Brak Light
1.The integrated head/ rear light is powered by the battery, which can
ensure your riding safety at night. The tail light provides three
operation modes: always on, strobe, and brake highlight. Combination
of three modes to ensure your riding safety and increased visibility at
night, which also can warn at critical times.
2. Anytime the bike is powered on, squeezing one or both brake
levers on the handlebar will cause the brake light to illuminate.
3. Pressing and holding the MODE and UP- arrow buttons when the
bike is powered on. The front light and the rear light will turn on, and
when the brake levers are squeezed, the brightness of the rear light
will turn to highlight.
4.To open the flash mode, press the rubber flash mode button on the
bottom left side of the taillight housing. When in flash mode, squeezing
the brake lever(s) will make it always highlight. Flash mode will
continue if the display is turned off but requires (the above) activation
by pressing the flash mode button once the battery has been turned
off and back on again.
To Next Page
Loading...
