continued on next page
4443
If it moves more than 1 in. (2.5 cm), you can try:
A. Reinstalling the base. B. Changing to a different
seating location. C. Switching to lower anchor/UAS belt
installation if lower/UAS anchors are available in your
vehicle.
If Using the Load Leg:
Rotate It Completely
Forward
If you are not using the load
leg, skip to step 12.
Extend the Load Leg
Squeeze the buttons on the
load leg and pull it down until it
meets the fl oor of the vehicle.
Release the buttons.
Lift the front of the base while
holding the load leg in place as
shown to lock it into position.
Make sure the load leg is
securely locked into position.
Check Belt Tightness
Hold the base at the belt path
with your weakest hand.
Push and pull from side to side.
It should not move more than
1 in. (2.5 cm).
10
119
Secure Child in Child
Restraint
See pages 26-28.
12
To Next Page