21
3. Route Vehicle Lap or
Lap/Shoulder Belt
Through Base Belt Path
Buckle vehicle belt.
4. Tighten Belt
Firmly push down and
towards the vehicle seat
back while pulling shoulder
belt or free end of lap belt
to tighten.
22
2. Check if Your Vehicle
Belts Will Work With
This Base
This is very important
because
not all vehicle
belts will work with child
restraints or bases.
Review pages 9-12 and your vehicle owner’s manual
to determine what kind of vehicle belt you have and
how to lock a child restraint/base in place.
1. Place Base in Vehicle
Rear Facing
Center the base in the
chosen seating position.
5. Check Belt Tightness
Hold the base at the belt
path with your weakest
hand.
Push and pull from side to
side. It should not move
more than 1 in. (2.5 cm).
If it moves more than 1 in. (2.5 cm), you can try:
A. Pulling the belt tighter.
B. Reinstalling the base.
C. Changing to a different seating location.
D. Switching to the lower anchor belt installation if
lower anchors are available in your vehicle.
continued on next page
To Next Page
Loading...
Need help?
General
