Maxi-Cosi Mico Series User Manual

20
To Release Lower Anchor
Belt
Remove lower anchor belt
from vehicle anchors by
pressing the red release but-
ton on each connector. Then
pull it out of the vehicle seat.
Store lower anchor belt
when not in use.
See page 7.
19
Vehicle Belt Installation
WARNINGS: Do not use the
lower anchor belt along with the
vehicle lap or lap/shoulder belt.
Secure the lower anchor connectors to
storage attachments as shown when
installing with vehicle belts.
Check the vehicle belt before each use. Use
only if the belt can be tightened properly and
locked securely in place.
Failure to follow these warnings can result in
serious injury or death.
continued on next page
You may need to place a large
rolled towel(s) or foam pool
noodle(s) under front of child
restraint to help make level line
parallel with the ground.
Check often to be sure pad-
ding is still in place and the
belt is tight.

Maxi-Cosi Mico Series Specifications

General

Height Limit	Up to 32 inches
Base	Included
Side Impact Protection	Yes
Type	Infant Car Seat
Base Compatibility	Compatible with Maxi-Cosi bases
Harness	5-point
Fabric	Machine washable
Canopy	Adjustable
Infant Insert	Yes
Stroller Compatibility	Compatible with Maxi-Cosi strollers
Additional Features	machine-washable fabrics