Moda
I
Convertible Car Seat
I
Maxi-Cosi
I
29
Installation
Forward-facing installation with vehicle belts
NOTE: There is an option to install seat using seat belt with accessory locking clip.
Please see instructions provided with locking clip for installation.
1. Adjust the child restraint to the forward facing
position and select desired seat angle by adjusting the
base to (‘LOW’, ‘MID’ or ‘HIGH’).
2. Place restraint on back seat of vehicle in line with a
top tether strap anchorage point.
3. Thread the vehicle seat belt through the back of the
seat though the
YELLOW forward-facing belt path.
4. Place one hand on seat and firmly press the child
restraint down into the vehicle seat and pull on
seatbelt to remove slack.
NOTE: If the car seatbelt is not long enough to
secure the child restraint, DO NOT USE SEAT BELT
EXTENDERS.
5. Attach the top tether strap to the anchorage point.
Adjust until all the slack is removed. Ensure Base of
seat is not lifted.
NOTE: Before you start installation, adjust the
shoulder straps and headrest to fit your child.
Refer to page 24/25.
PUSH
PUSH
CLICK
SELECT:
‘LOW’
‘MID’
‘HIGH’
NOTE: These images are for reference and illustration purposes only. We recommend
the use of the provided stabilising bar cover and the seat mat when installing
this product (if fitted).
To Next Page
Loading...
