Maxi-Cosi Moda - Forward-facing using ISOGO

32
I
Moda
I
Convertible Car Seat
I
Maxi-Cosi
Installation
Push the red button, located on the front of the
base, inwards to select the desired seat angle:
‘LOW’, ‘MID’ or ‘HIGH’.
Place the car seat in the vehicle, facing forward.
Release belt to full length by pressing grey button
and pulling adjuster. Repeat for both sides.
Locate low anchorage points. You can find this by
looking for the ISOFIX logo located on the vehicle
seat.
Attach the lower connector on both sides. Listen
for a “click!”
PUSH
& PULL
CLICK!
BOTH SIDES
NOTE: You can move the car seat out of the way to locate and attach the connectors,
then place back into position before tightening.
PUSH
SELECT:
‘LOW’
‘MID’
‘HIGH’
1. Select the desired seat angle
2. Attaching ISOGO lower connectors
Forward-facing using ISOGO
(12 months to 4 years approximately)
NOTE: These images are for reference and illustration purposes only. We recommend
the use of the provided stabilising bar cover and the seat mat when installing
this product (if fitted).