Moda
I
Convertible Car Seat
I
Maxi-Cosi
I
37
Infant Insert
To remove insert:
To remove the insert, undo the buckle and pull the insert out.
To replace insert:
Feed the crotch part of the buckle through the opening slot in the
insert and fasten buckle assembly.
Belt Mates
To remove belt mates:
To remove the belt mates, simply undo press studs and unwrap
from harness straps.
To replace belt mates:
Fit belt mates to harness straps by wrapping around straps and
closing press studs.
VERY IMPORTANT:
Only replace the cover with a manufacturer’s supplied
replacement cover with identical shoulder height markers
or a replacement cover meeting AS/NZS 8005.
Care and maintenance
Removing the seat cover for cleaning
NOTE: Style and design may vary.
Car Seat Protector Mat (if fitted)
To remove car seat protector mat:
To remove, loosen o the installation of your car seat, and pull the
mat out from underneath.
To replace car seat protector mat:
To replace centre mat underneath car seat and tighten installation.
Stabilising Arm - Soft Cover
To remove stabilising arm - soft cover:
To remove, slowly stretch the guard o one side, followed by the
other.
To replace stabilising arm - soft cover:
To replace, stretch one side of the cover over the stabilising arm,
followed by the other. Check that the Maxi-cosi logo is facing up
when stabilising bar is extended.
To Next Page
Loading...
