Maximum Controls MATRIX III MAX 1200FS PRO - Page 32

Polarity does ./4 matter

# ./ .#
,)'(4/.
3%.3)4)6)49
-IN -AX
$!2+/.
0OWER
3ETSWITCHTO
h,)'(4/.v
TO6!#
TO6$#

#
 
.#
3ENSITIVITY!DJUSTMENT
If the photocell does not respond to an
obstruction, lower the sensitivity by
turning adjustment counter-clockwise.
/+TO
USE
6$#
'.$
Photocell (Reflector)
OPENING Direction
NOTE: To meet the UL 325 2018 standard,
Type B1 Non-Contact sensor entrapment
protection device MUST be MONITORED
by the gate operator.
)NSTALLATION3TEPS
 Set switch to “LIGHT ON”
 Wire 12V power to photocell
 Wire /0%./.,9+
to photocell .#
Wire '.$ to photocell #
 Align photocell to reflector
 Adjust sensitivity
10K Resistor wiring to E3K Photocell
UL325-2018
OPEN ONLY NC
OPEN ONLY 10K
PHOTO CLS NC
OPEN/CLS NC
GND
12VDC OUT
GND
CLS ONLY 10K
OPEN/CLS 10K
12VDC OUT
UL SENSOR N.C.
UL SENSOR 10K
P
P
P
P
6$#/54
.#
. #
omron E3K-R10K4 wiring for max pro
5,,ABELONPACKAGING
5,3TANDARD-!8&302/&302/-ATRIX))))NSTALL6ERSIONB
