23
MAX Super 1300/2300 Arms V1B
clo
s
e
open
CLOSE
close
o
pe
n
“BEEP/ALARM”
11. Rotate CLOSE limit screw until BEEP/ALARM is heard.
(Close limit screw is adjusted for the OPEN position of gate)
13. Re-lock Manual release.
12. When satisfied with Open and Close positions of gate, permanentely secure front bracket.
14. Learn newly adjusted limits on control box. Push the OPEN button, gate will open
and learn open limit. Push the CLOSE button, gate will close and learn close limit.
NOTE: Gate may not ramp down when approaching limits while “LEARNING”
gate positions but will ramp down after limits have been learned.
NOTE: If 2 consecutive beeps are heard when moving gate to OPEN position,
then adjust gate to FIRST BEEP/ALARM position.
CAUTION: If BEEP/ALARM is NOT heard, readjust front bracket position.
NOTE: Rotate CLOSE limit screw in “MINUS ” direction for gate to open LESS.
Rotate CLOSE limit screw in “PLUS ” direction for gate to open FURTHER .
Operator MUST be wired to control box. Control box MUST have power.
2. Mount actuator arm on REAR bracket ONLY .
3. Manually release actuator arm. See page 12.
4. Retract shaft until a BEEP/ALARM is heard from
control box.
5. Extend shaft to 3 1/4” (typical) as shown.
This will be CLOSE position of operator.
6. Bolt FRONT bracket to operator.
7. Manually move gate to CLOSE position.
1. Clear limits from control box memory. Press and HOLD STOP
and CLOSE buttons together for 5 sec. until BEEP/ALARM is heard.
Screen will display “LEARNING LIMITS ”.
9. Make sure gate remains in CLOSE position. Rotate OPEN limit screw until
BEEP is heard. (Open limit screw is adjusted for the CLOSE position of gate)
10. Manually move gate to OPEN position.
OPEN
REAR
bracket
secured
8. With operator shaft in same position,
temporarily mount FRONT bracket
(Clamp or tack weld) to gate in the CLOSE position.
MOTION CONTROL
OPEN
STOP CLOSE
LEARNING LIMITS
push open 1300 install
GATE
PULL
OPEN
PUSH
OPEN
NOTE: Rotate OPEN limit screw in “MINUS ” direction for gate to close LESS .
Rotate OPEN limit screw in “PLUS ” direction for gate to close FURTHER .
“BEEP/ALARM”
“BEEP/ALARM”
MOTION CONTROL
OPEN
STOP
CLOSE
Rear bracket already secured to gate post
Learn Adjusted Limits
Open
Close
NOTE: If limits need to be re-adjusted, then they MUST be cleared first from control box memory, see #1 above.
Gate is CLOSED
Gate is OPEN
Manual Release
Retract
“BEEP/ALARM”
3 1/4”
Typical
(2.16” Min)
CLOSE position
Extend
Bolt on FRONT bracket
Re-lock Manual Release
Adjusting Limits
(See note below)
See page 12.
max super arm 1300
Rev 06-21-22
To Next Page
Loading...
