24
MAX Super 1300/2300 Arms V1B
CLOSE
close
open
c
lose
o
pe
n
11. Rotate CLOSE limit screw until BEEP/ALARM is heard.
13. Re-lock Manual release.
14. Learn newly adjusted limits on control box. Push the OPEN button, gate will open
and learn open limit. Push the CLOSE button, gate will close and learn close limit.
NOTE: Gate may not ramp down when approaching limits while “LEARNING”
gate positions but will ramp down after limits have been learned.
NOTE: If 2 consecutive beeps are heard when moving gate to CLOSED position,
then adjust gate to FIRST BEEP/ALARM position.
CAUTION: If BEEP/ALARM is NOT heard, readjust front bracket position.
Re-lock Manual Release
NOTE: Rotate CLOSE limit screw in “MINUS ” direction for gate to close LESS.
Rotate CLOSE limit screw in “PLUS ” direction for gate to close FURTHER .
2. Mount actuator arm on REAR bracket ONLY .
3. Manually release actuator arm. See page 15.
4. Retract shaft until a BEEP/ALARM is heard from control box.
5. Extend shaft to 3 1/4” (typical) as shown.
This will be OPEN position of operator.
6. Bolt FRONT bracket to operator.
7. Manually move gate to OPEN position.
1. Clear limits from control box memory. Press and HOLD STOP
and CLOSE buttons together for 5 sec. until BEEP/ALARM is heard.
Screen will display “LEARNING LIMITS ”.
10. Manually move gate to CLOSE position.
“BEEP/ALARM”
“BEEP/ALARM”
“BEEP/ALARM”
“BEEP/ALARM”
OPEN
3 1/4”
Typical
(2.16” Min)
REAR
bracket
secured
Manual Release
Bolt on FRONT bracket
OPEN position
8. With operator shaft in same position, temporarily
mount FRONT bracket (Clamp or tack weld) to gate in
the OPEN position.
Retract
MOTION CONTROL
OPEN
STOP CLOSE
LEARNING LIMITS
Extend
9. Make sure gate remains in OPEN position. Rotate OPEN limit screw until
BEEP/ALARM is heard.
NOTE: Rotate OPEN limit screw in “MINUS ” direction for gate to open LESS .
Rotate OPEN limit screw in “PLUS ” direction for gate to open FURTHER .
pull open 2300 install
GATE
PULL
OPEN
PUSH
OPEN
Operator MUST be wired to control box. Control box MUST have power.
12. When satisfied with Open and Close positions of gate, permanentely secure front bracket.
Rear bracket already secured to gate post
Close
Open
MOTION CONTROL
OPEN
STOP
CLOSE
Learn Adjusted Limits
NOTE: If limits need to be re-adjusted, then they MUST be cleared first from control box memory, see #1 above.
Adjusting Limits
(See note below)
See page 15.
max super arm 2300
Rev 06-21-22
To Next Page
Loading...
