10 11
model no. 054-0252-2 | contact us 1-888-670-6682
Turn the container upside down. Insert
the two casters into the sockets on the
bottom of the base and apply pressure
until casters snap into place.
Position the hose storage rack as
illustrated. Insert one side of the rack
into the channel, making sure it is
secured in place. Squeeze in the other
end and insert it into the corresponding
channel, making sure it is secured.
Fitting the wheels, see below for detail
description.
For dry vacuum cleaning, install the
supplied cartridge filter and dust bag.
5
7
6
8
For wet vacuum cleaning, install the
supplied foam filter.
Place the power head back on the
container, and secure into place using
the 2 side latches.
Fit the required accessory on to the
suction tube.
Replace the top section on the tank.
Insert the large end of the hose into the
front inlet of the tank and turn to lock.
11
13
9
10
12
GENERAL ASSEMBLY INSTRUCTIONS
GENERAL ASSEMBLY INSTRUCTIONS
1
2
To Next Page
Loading...
General