14 15
model no. 054-0252-2 | contact us 1-888-670-6682
Vacuuming Liquids
Ensure that the power cord is
disconnected from the power outlet.
Ensure that the tank is clean and free of
dust and dirt.
Fit the desired nozzle to the vacuum
hose.
1
3
Remove the cartridge filter and install
a foam filter over the filter basket and
place the top section back on the tank.
Ensure that the switch is in the “O”
position before plugging the power
cord into the power outlet.
2
4
WARNING!
Before starting ensure to read, understand, and apply the safety
instructions in section 1. Reminder: do not vacuum hazardous
substances.
REMEMBER!
The foam filter must be removed after wet vacuuming, and a
cartridge filter must be installed before dry vacuuming again.
After use, flip the switch to the “O”
position and unplug the power cord,
then empty and dry the tank.
6
Switch the Wet/Dry Vacuum on.
5
WET VACUUM OPERATION
WET VACUUM OPERATION
When vacuuming large quantities of liquid from a sink or tank etc., do not immerse
the nozzle completely into the liquid; leave a gap at the top of the nozzle opening to
allow for air inflow. The machine is fitted with a float valve that stops the suction when
the tank reaches its maximum capacity. An increase in motor speed will be noticed.
When this occurs, turn off the machine, disconnect from the power supply, remove
the head from the tank and empty the liquid into a suitable receptacle or drain. To
continue vacuuming, refit the head and proceed. After wet vacuuming, turn the
machine off and remove the plug from the power supply. Empty the tank and clean
and dry the inside and the outside before storage.
To Next Page
Loading...
General